Instruction Manual

Connection Example
•
133
Warning
The DIN-814M is used for wiring between Mitsubishi J2S series servo
drivers and ADLINK PCI-8134/PCI-8134A, PCI-
8164, or MPC-8164
motion controller card ONLY.
8.3
Wiring with DIN-814M
Note:
1. The DIN-814M provides 2 connection methods for every axis. The first
is through the CNA & CNB connectors. This is for Mitsubishi J2S series
servo driver. The second is through SJ connector. This is for stepping
driver or other servo drivers (for Panasonic MINAS MSD driver, please
use DIN-814P). Keep in mind that the signals in SJ and CNA & CNB of
4th Axis
To
Mitsubishi
J2S
Driver
3rd
Axis
To
Mitsubishi
J2S Driver
A B B
GND
+24V
Mechanical I/O
Interface
CNA-(4)
CNB-(4) CNB-(3)
CN1
HD-(4) HD-(3)
IOIF-(4)
A
To
PCI-8134/8164
IOIF-(3)
IOIF-(2)
A
IOIF-(1)
LED indecater
To stepping
driver
J1~J4
HD-(1) HD-(2)
-(1) : for 1st axis
-(2) : for 2nd axis
CNA-(1)
CNB-(1) CNB-(2)
-(3) : for 3rd axis
A B B
-(4) : for 4th axis
1st Axis
To
Mitsubishi
J2S
Driver
2nd Axis
To
Mitsubishi J2S
Driver
the same axis are directly shorted. DO NOT use both connectors at the
same time.
2. Two one-to-one 20-PIN cables are required for connection between the
CNA & CNB and the Mitsubishi J2S driver. It is available from ADLINK,
or users may contact the local dealer or distributor to get cable
information.