Owner's manual

Table of Contents i
Table of Contents
Table of Contents..................................................................... i
List of Tables........................................................................... v
List of Figures ........................................................................ vi
1 Introduction ........................................................................ 1
1.1 Features............................................................................... 4
1.2 Specifications....................................................................... 6
1.3 Supported Software............................................................. 8
Programming Library ...................................................... 8
MotionCreatorPro ........................................................... 8
1.4 Available Terminal Board..................................................... 8
2 Installation .......................................................................... 9
2.1 Package Contents ............................................................... 9
2.2 PCI-8154 Outline Drawing ................................................. 10
2.3 PCI-8154 Hardware Installation......................................... 11
Hardware configuration ................................................. 11
PCI slot selection .......................................................... 11
Installation Procedures ................................................. 11
Troubleshooting4: ......................................................... 11
2.4 Software Driver Installation................................................ 13
2.5 CN3 Pin Assignments: Main Connector ............................ 13
2.6 K1/K2 Pin Assignments: Simultaneous Start/Stop ............ 15
2.7 JP2 to JP9 Jumper Setting for Pulse Output ..................... 15
2.8 SW1 Card Index Selection................................................. 16
2.9 CN4 Manual Pulsar............................................................ 17
3 Signal Connections.......................................................... 19
3.1 Pulse Output Signals OUT and DIR .................................. 20
3.2 Encoder Feedback Signals EA, EB and EZ....................... 23
3.3 Origin Signal ORG ............................................................. 26
3.4 End-Limit Signals PEL and MEL........................................ 27
3.5 In-position Signal INP ........................................................ 28
3.6 Alarm Signal ALM.............................................................. 29
3.7 Deviation Counter Clear Signal ERC................................. 30
3.8 General-purpose Signal SVON.......................................... 31