User Manual

Installation 17
2.8 Jumper Settings
The PCI-6308‘s voltage output channels can be configured with
different voltage range. Each output channel and its corresponding
jumpers are listed below.
Table 2-2: Channel Jumper Settings
The output range is dependent on the D/A converter's reference
voltage source and output mode (Bipolar or Unipolar). JP11 and
JP12 are used for setting reference voltage sources from either
internal or external. External reference voltage input (ExtVref) is
located on connector CN1. JP1~8 and JP9/10 are used to set the
output mode to be unipolar or bipolar.
Channel NO.
Corresponding Jumper
For output mode
(Unipolar/Bipolar)
Corresponding Jumper For
reference voltage sources
(external/internal)
CH0 JP1 JP9 JP11
CH1 JP2 JP9 JP11
CH2 JP3 JP9 JP11
CH3 JP4 JP9 JP11
CH4 JP5 JP10 JP12
CH5 JP6 JP10 JP12
CH6 JP7 JP10 JP12
CH7 JP8 JP10 JP12