Owner's Manual

INSTALLATION
 This refrigeration system will operate best when it is installed in an area that has cool, dry
air.
 Do not put in direct sunlight.
 Be sure that the unit is properly grounded. All units are equipped with a three-prong ground
plug on the service cord for your safety.
 Make sure that there is at least 6 inches of clearance on both sides and the back of the
cabinet.
 This refrigeration system should be located away from heat and moisture-generating
equipment such as ovens, etc
 Unit should be installed on a surface that can support the weight of the entire unit including
its contents. Surface should also be flat.
 This unit was designed for indoor use only. Outdoor use will void any warranty.
PRECAUTIONS
 Use caution to not overload the outlet
 Do not use flammable products near the unit or spray the unit with water
 If you must unplug the unit, you must wait at least 6 minutes before plugging it back in. If
you do not wait the 6 minutes, the compressor may fail.
 When cleaning:
 Be sure to unplug the power cord with dry hands prior to cleaning
 Cracking or discoloration of plastic parts may occur if you use harsh abrasive solvents or
polishing agents. Avoid such products.
 If you will not be using the unit for an extended period of time, unplug the unit, wipe the
inside with a dry cloth. Door may be left slightly open to eliminate moisture and odor
OPERATION AND MAINTENANCE
 When loading the unit:
 Do not block the air ducts (located at the back and top of the unit) with product as this
will block the air flow thereby decreasing the unit’s performance. For best results, keep
at least 6 inches of clearance between the product and the air duct.
 The temperature controller is located at the right, front corner of the ceiling. The default
setting is “4”.
 Do not leave the unit door open for extended periods of time when the unit is on and
plugged in. For best results, close the door immediately after use.
