Installation Guide

Single Garage Door Insulation Kit Installation Instructions for 8x7 or 9x7 door
1) Make sure the garage door panels are clean and dry. This allows for retainer pins to adhere properly.
2) Mark each door section in two places. Each mark should be 12 inches from the edge
and in the center of the panel. See diagram 2A. See PIC 1.
3) Peel the paper backing off of the self sticking retainer pins and attach to the door panels
where you made your marks. Each panel should have two retainer pins. When working with
the retainer pins it is recommended that you wear puncture resistant gloves. See PIC 2 & 3.
4) Measure the height and width of each garage door panel. Add one inch to each measurement
to ensure a good snug fit with no gaps.
5) Unroll the insulation vinyl side down. When working with fiberglass insulation it is
recommended that you wear gloves and an N95 facemask. See PIC 4.
6) Cut the insulation for each panel. When using a utility knife it is recommended
that you use cut resistant gloves. See PIC 4.
7) Place the insulation into the panel vinyl side facing out, tuck in the edges and top. Once you
have the edges and top lined up carefully puncture the insulation onto the retainer pins. When
working with the retainer pins it is recommended that you wear puncture resistant gloves.
8) Push the retainer pin cap onto retainer pin. Do not push too hard, just enough so the cap
grips onto the pin. See PIC 6.
EASY TO INSTALL/ INSTALACIÓN SENCILLA/ FACILE À INSTALLER
Kit includes:
1-roll of R-8 vinyl faced insulation
(22”w x 37’L)
17-self sticking retainer pins
17-retainer pin caps
Kit has 1 extra pin & cap
Tools needed:
Utility knife
Tape measure
Marking pen
Puncture and cut resistant gloves
Straight Edge
2905 Northwest Boulevard, Suite 230 | Plymouth, MN 55441 | Phone: [phone] | Fax: [phone] | Website: www.adoproducts.com
MEASURE/MEDIDA/
MESURE
PEEL/PELE/
PELEZ
PLACE/COLOQUE/
PLACER
CUT/CORTE/
COUPE
INSTALL/INSTALAR/
INSTALLER
CAP/TAPA/
COUVRIR
ENJOY/DISFRUTA/
JOUIR
Diagram 2A
8’ or 9’ length
7’ height
1
2
3
4 5 6 7
© 2016 ADO Products, LLC