User's Manual

Install Your Wireless Mouse
Hardware Installation
Installing Batteries
1. Remove the battery cover from the bottom of your mouse.
(1)（Press down the lid on the bottom of the mouse）
(2)（The top shell pops out automatically. Push forward the top shell.）
2. Insert two AA Alkaline Batteries into the battery compartment.
3. Replace the cover carefully.
l Once the battery is placed correctly in the mouse, the optical LED located
at the mouse bottom will light up.
Connect the Mouse
To connect to a USB port (Windows 98 or higher required), connect the USB
receiver to the USB port on the computer.
To connect to a PS/2 port, TURN OFF your computer before installation.
1. Connect the PS/2 adapter to the USB receiver.
2. Insert the receiver i nto the PS/2 port on the computer.
3. Turn on your computer.
If you work under Windows environment, you may be prompted to insert the
Windows software CD. Please insert this CD into the computer’ s CD-ROM
when you are asked to do so and follow the on-screen instructions.
Establishing a Communication Link
First of all, please find out if you bought a 400 cpi or 800 cpi mouse. (Please
refer to the label on the box.)
For 400 cpi mouse
1. After you insert the receiver to your computer, the receiver will not light up or
blink;
2. Please press the reset button on the back of your mouse in 3 minutes;
reset button
3. When the receiver link with the mouse successfully, the LED of the receiver
will blink.