PRODUCT GUIDE & ASSEMBLY INSTRUCTIONS Bed
Should you prefer to speak with a customer service representative, you may call toll free: 1-855-372-2315 2
Guidelines FAILURE TO FOLLOW THESE WARNINGS WHEN IN USE COULD RESULT IN INJURY • Do not stand on the item or use as a step ladder • Do not use this item unless all bolts and screws are firmly secured and fastened. • Check all bolts and screws every 90 days. As necessary tighten if any are loose. • Lift up then move. Pushing over or dragging this product can result in an injury or cause damage to the floor and piece.
WARNING: DO NOT LET CHILDREN PLAY IN OR AROUND THE UNIT DUE TO THE POSSIBLE RISK OF INJURY. Pre-Assembly Preparation: Please read through this instruction booklet before beginning assembly of this item. Two adults are recommended for assembly. • Clear out the space for assembly and lay out all parts on Parts List, extra room will allow you to easily determine if all the pieces are present. • Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or hardware.
Parts List Headboard (1) Footboard (1) Side Rail (2) Legs (4) Center Rail (1) Support Legs (2) Slat (28) Middle Holder (14) End Holder (28) 5
Parts List JCBC M6X40 (2) M5X70mm (1) M4X65mm (1) CSK M4X25mm (18) Adjuster (2) JCBB M8X20 (8) M6 Flat Washer (16) 6
Step 1 Install the legs (D) to footboard (B) and headboard (A). Then tighten the legs.
Step 2 Attach side rail (C) to footboard (B) and headboard (A) by pushing the bracket down to fit it.
Step 3 Attach the support legs (F) to the center rail (E) of the bed as shown. Please keep the adjuster around 5 to 8 mm distance away from the floor.
Step 4 Slide the center rail (E) to the headboard (A) and footboard (B). Tighten screws (M) using screw driver (not included) to the headboard (A) and footboard (B).
Step 5 Tighten all 4 corners, then assemble the slat holders with LVL slats as shown.
Product Dimension 7”/ 64.5 43.7” / 1110 mm 86.
Limited Warranty The manufacturers products are warrantied against defects in material and workmanship while owned by the “Original Purchaser”. The term “Original Purchaser” is defined as the party or entity which purchases this manufacturer’s furniture from an authorized retailer as shown by the original sales receipt. This warranty does not apply to “as is” or previously owned products.