Installation Guide

ADORN® STONE VENEER SIDING PRODUCTS ARE UNDER WARRANTY FOR A LIMITED LIFETIME FROM THE DATE OF PURCHASE
WHEN INSTALLED IN CONFORMANCE TO LOCAL BUILDING CODES AND MANUFACTURER’S INSTRUCTIONS. NCP WILL REPLACE ANY
MATERIAL DEEMED DEFECTIVE AT NO CHARGE.
THIS WARRANTY IS LIMITED TO THE ORIGINAL PURCHASER AND MAY NOT BE TRANSFERRED.
THIS WARRANTY DOES NOT COVER DAMAGE RESULTING FROM THE FOLLOWING:
SETTLING OF BUILDING, CONCRETE FOUNDATION OR OTHER STRUCTURAL MOVEMENT
DISCOLORATION DUE TO AIRBORNE CONTAMINANTS; CONTACT WITH CHEMICALS OR PAINT; STAINING OR OXIDATION
USE OF A NON-BREATHABLE SEALER.
USE OF QUALITY EXTERIOR CONSTRUCTION NAILS OR SCREWS. NCP IS NOT RESPONSIBLE FOR THE CORROSION RESISTANCE
OF FASTENERS. TREATED LUMBER MAY REACT WITH METAL OR COATING OF FASTENER. DETERMINE COMPATIBILITY WHEN
SELECTING FASTENERS.
THIS WARRANTY COVERS ONLY MANUFACTURING DEFECTS IN STONE VENEER SIDING PRODUCTS MANUFACTURED BY NCP
INDUSTRIES.
LIMITED LIFETIME WARRANTY
NCP IS NOT RESPONSIBLE FOR LABOR COSTS INCURRED IN REMOVAL AND REPLACEMENT OF DEFECTIVE PRODUCTS.
THE OWNER MUST RETURN THE DEFECTIVE STONE VENEER SIDING TO THE DEALER WHO SOLD THE PRODUCT. ANY IMPLIED
WARRANTIES OF MERCHANTABILITY AND/OR FITNESS FOR A PARTICULAR PURPOSE ARE LIMITED IN DURATION AS STATED ABOVE.
THE EXCLUSIVE REMEDY UNDER THIS WARRANTY IS THE REPLACEMENT OF THE DEFECTIVE STONE VENEER SIDING.
NCP INDUSTRIES SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGE ARISING FROM ANY BREACH OF WARRANTY.
IMPORTANT NOTICE:
IN ORDER TO MAKE A CLAIM UNDER THIS WARRANTY,
FOR CLAIM ASSISTANCE CONTACT:
NCP INDUSTRIES
PO BOX 636 | NORFOLK, NE 68701
888.379.2210 | NCPINDUSTRIES.COM
Attach the base course first.
Place 4 Post Stones around the base of the 6” X 6” post as shown.
Level the base course and attach with 2 screws per Post Stone
Continue installing the Post stones one course at a time.
Square up the corners, check for level and attach with screws.
through the attaching flange approximately 1” above the stone veneer.
Installing Post Stone
Installing Pillar Stone
Construct the pillar base using 2"x 2"s and OSB or plywood to the desired height.
Each Pillar Stone is 6" high so designing the height in 6" increments will eliminate cutting of the Pillar Stones.
The outside dimensions need to be 14"x14".
Cover the frame with an ice and water resistant type of wrap.
PRO TIP: It is recommended to use treated lumber (2"x4") on the base. Anchor the pillar as needed.
Attach the base course:
Place 4 Pillar Stones around the
base as shown.
Level the base course and attach
with 2 screws per Pillar Stone
through the attaching flange
approximately 1" above the stone
veneer.
Continue installing the Pillar Stones
one course at a time.
Square up the corners, check for
level and attach with screws.
When you get to the top course,
bend the flashing over the frame
and screw into place.
Place a bead of construction
adhesive around the top of the
Pillar Stone.
Set the ADORN Pillar Cap in place.
The finished pillar will be
approximately 18” square.