User's Manual


AdvancedRFTechnologies,Inc.  29

3.1.1.2 EthernetPort
TheEthernetportcanbeusedtocommunicatedirectlywiththeADXDASusingaRJ‐45crossovercableorcan
alsobeusedtoconnecttheADXDAStoanexternalmodembox.
HOST HE VIEW
REMOTE RU VIEW

Figure3‐4 EthernetPort


3.1.1.3 Host/RemoteSwitch
TheHost/RemoteSwitchallowstheusertoswitchthedefaultRepeaterIP,SubnetMask,andGatewayofthe
repeatertoan alternativesetup.Thesesettingscanbeadjustedbyloggingintothe ADXDAS in HOSTmodeand
configuringthesettings
undertheModemBoxSettingsectionundertheInstallPageofNMS. 
Oncethesettingsareset,flipping theswitchto theREMOTEposition willrebootNMSmodulewiththe new
alternatesettings.Pleasenotethatwhenthe NMSis settotheREMOTE position, DHCPisdisabledandthe NMS

willnotautomaticallyassignanIPaddresstoanydevicethatconnectsdirectlytotheNMS.

HOST HE VIEW
REMOTE RU VIEW

Figure3‐5 Host/RemoteSwitch
 HostIP:192.168.63.1(FixedIP,unabletomodifythisIPaddress)
 RemoteIP:192.168.63.5(DefaultIP,butcanbemodifiedinHostmode)
3.1.1.4 HEView/RUViewSwitch
TheHEView/RUViewSwitchallowstheusertodisabletheperiodicmonitoringperformedby
theNMS.Inthe
HEviewmode,theNMSmonitorsthestatusofallsubordinateunitsconnectedtoNMSbutwhenswitchedtoHPR
view theNMS does not monitor the subordinate units.HPRViewmodewill allow theuser to go to a HPR and
monitor/controltheHE.Ifthe
NMSissettotheHEViewmodeandtriestoconnecttoaHPRtomonitortheHE,
datacollisions between theNMS and HPR mayprevent theuser fromproperly monitoring or configuring theHE
whenattheRU.
HOST HE VIEW
REMOTE RU VIEW

Figure3‐6 HEView/RUViewSwitch
 