User's Manual


AdvancedRFTechnologies,Inc.  47


6.2 ADXDASInstallationProcedure
6.2.1 HEInstallationProcedure
CAUTION: ADXDASHEshouldbeinstalledinsidebuildingonly.

6.2.1.1 InstallingaADXDASHEinarack
TheADXHEchassismountsinastandard19”(483mm)equipmentrack.Allowclearanceof3”(76mm)atthe
frontandrear,and2”(51mm)onbothsidesforaircirculation.Notoporbottomclearanceisrequired.

 Consideration:
‐
Eightmountingholesarelocatedon4cornersofADXHEtoattachittothe19”rack.TheADXHE
mustbesecurelyattachedtoarackthatcansupporttheweightoftheADX.
 Mountprocedure
‐ ThefollowingstepsshouldbefollowedwhilemountingtheADXHE

 DetachthewallmountbracketassembledlocatedatthebaseoftheADX‐HEchassis
 VerifythattheHEandMountingholesareingoodcondition
 SettheADXDASHEagainstthe19”rackandsecuretheunitwithscrews
 VerifythatADXHEissecurely
attached
 ConnecttheGNDcable
 ConnecttheRFcable
 ConnectthePower
 ConnecttheOpticcable