User's Manual


AdvancedRFTechnologies,Inc.  56

7.1.3 CheckNavigationTreeStatus
 CheckwhetherthestatusofnavigationtreeisLockorUnlock.
 Thenavigationtreeshouldbeinthe“Unlock”stateinwhenaddingorremovingactiveADXcomponents.

Figure7‐2 NavigationtreeLock/Unlock

Whenthesystemislocked:
 Unabletodetect
anyhardwarethatisadded
 Abletodetectanylinkfails(communicationerrorsbetweenNMSandcomponents)
 Systemshouldbelockedafterfinalcommissioning
Whenthesystemisunlocked:
 UnabletoperformBCU,RFU,orHPRcommissioning
 Systemiscontinuallyscanningfornewhardware
7.1.4 Set
LocationInfo,InstallerInfoandDate&Time
 GototheInstallpageofNMS
 EnterLocation&installerinformation
 SetcurrentDate&Time
7.1.5 VerifyNavigationTreeLinks
 CheckwhetherallunitsconnectedtoHE&HPRarebeingdisplayedinthenavigationtree.
‐
NavigationtreeislocatedontheleftsideofWeb‐GUI(Figure7‐3)

Figure7‐3 Navigationtree
 Checkwhetherlinkfailsexist.LinkfailsstatuscanbeseenonthefrontpanelofNMSmoduleviatheLinkFail‐
HandLinkFail‐RLEDlights.

‐ IfLINK‐Hfailexists,powercycletheHEPSUandcheckifLINK‐Hfailisstillpresentandrepeatthis
stepupto 3 times or until thealarm clears.If LINK‐Hfail still exists after3 powercycles, then
contactADRFTechnicalsupport.
‐ If
LINK‐Rfail exists, powercycletheADX‐H‐ODUmodule which isconnectedtothe Master HPR
withlinkfailandchecktoseeiftheLINK‐Rfailisstillpresentandrepeatthisstepupto3timesor
until the alarm clears. If LINK‐R fail still
 exists after 3 power cycles, contact ADRF Technical
support.
 