User's Manual


AdvancedRFTechnologies,Inc.  75

 DLInput:DisplaysthecurrentlyincomingsignalstrengthofeachRFpathalongwiththecompositeDL
inputpowerof all3RFpaths.
 Atten: Displays the attenuation values that the system is currently using which is defined by the
powerratioss pecifiedbytheuser.
 DL
Output:DisplaystheoutputvalueforeachRFpathalongwiththecompositeDLoutputpowerof
all3RFpaths.TheDLOutputlevelforeachRFpathwillnotexceed5dBmandthecompositeoutput
powerwillnotexceed10dBm.
8.2.2.2.3 PowerRatio

Figure8‐13
Status–BCUPowerRatio
 TargetedDLOutputPower:Displaysdesiredpowerratiosspecifiedbytheuser.Ifunithasnotbeen
commissioned,“NotCommissioned”willbedisplayed.
 Actual DL OutputPower:Displaysthe currently powerratiosthatthesystemis using.These values
willfluctuatebasedon
theamountoftrafficthatisinthesystem.
8.2.2.2.4 Alarm
DisplaysthecurrentalarmstatusofeachindividualRFpath.ParametersforbothDLSignalLowandDLInput
OverloadcanbespecifiedfromtheControltab.

Figure8‐14 Status–BCUAlarm

 