User's Manual

Advanced RF Technologies, Inc.

6.2.2 RU Installation Procedure

Wall mounting the ADX HRU

x Mount procedure

- The following steps should be followed while mounting the Remote Module

! Verify that the HRU and Mounting hole are in good condition

! Separate the wall mount bracket from the HRU

! Placed the wall mount bracket against the wall and mark off the mounting holes

! Drill holes(4holes, 18Żmm) in the installation surface then insert the enclosed anchor bolts

! Bolt the mounting bracket to the wall

! Install the HRU to the mounting bracket

! Fasten the HRU to the mounting bracket using the included screws

! Verify that the HRU is securely attached

! Connect the Antenna cable

! Connect the Power

! Connect the Optic cable (if applicable)