User's Manual

Advanced RF Technologies, Inc.

6.2.2.2 Wall mounting the ADX DAS RU

If the ADX RU chassis is being mounted to a wall, then allow clearance of at least 16” (406mm) on the top

(front side of RU), 2” (51mm) on the bottom (rear side of RU) and 2” (51mm) on both sides and front for air

circulation.

x Mount procedure

- The following steps should be followed while mounting the ADX RU

! Verify that the RU and Mounting hole are in good condition

! Place the RU chassis up against the wall and mark off the mounting holes

! Drill holes(4holes, 18Żmm, 50mm depth) in the installation surface and insert the anchor bolts

! Bolt the RU chassis to the wall

! Install the individual Sub-RU inside of the chassis

! Make sure the RU chassis is securely attached

! Connect the RF cable

! Connect the Antenna cable

! Connect the Power

! Connect the Optic cable

Figure 6-5 ADX-RU Wall Mount Instructions