User's Manual

Advanced RF Technologies, Inc.

Figure 3-5 NMS AAI

NMS has 5 external alarms out interface pins on the front panel.

Table 3-2 NMS AAI Specifications

AAI Alarm Status

Output

Normal

High Impedance (Open)

Alarm

Low Impedance (Short)

3.1.1.3 Ethernet Port

The Ethernet port can be used to communicate directly with the ADXV DAS using a RJ-45 crossover cable or

can also be used to connect the ADXV DAS to an external modem box.

Figure 3-6 Ethernet Port

3.1.1.4 Host/Remote Switch

The Host/Remote Switch allows the user to switch the default Repeater IP, Subnet Mask, and Gateway of the

repeater to an alternative setup. These settings can be adjusted by logging into the ADXV DAS in HOST mode and

configuring the settings under the Modem Box Setting section under the Install Page of NMS.

Once the settings are set, flipping the switch to the REMOTE position will reboot NMS module with the new

alternate settings. Please note that when the NMS is set to the REMOTE position, DHCP is disabled and the NMS

will not automatically assign an IP address to any device that connects directly to the NMS.

P(+) N(-)

LAN1

LAN0