User's Manual

Advanced RF Technologies, Inc.
41
5.2 RU
5.2.1 Rack Mount
Figure 5-2 RU Rack Mount Front and Rear View
6. INSTALLATION
6.1 Pre-Installation Inspection
Please follow these procedures before installing ADXV RU equipment:
o Verify the number of packages received against the packing list.
o Check all packages for external damage; report any external damage to the shipping carrier. If
there is damage, a shipping agent should be present before you unpack and inspect the contents
because damage caused during transit is the responsibility of the shipping agent.
o Open and check each package against the packing list. If any items are missing, contact ADRF
customer service.
o If damage is discovered at the time of installation, contact the shipping agent.
o Verify the AC voltage with DVM (Volt meter) is 110V AC. Incorrect AC voltage can damage the
ADXV equipment.
o This power of this system shall be supplied through wiring installed in a normal building. If
powered directly from the mains distribution system, it shall be used additional protection, such
as overvoltage protection device.
o Over voltage category(OVC) & Pollution degree(PD)
Over voltage category (OVC)
OVC II
SD SD
RU1RU2RU3BATTERY
OFF – AC - ON
RU4RU5ORUALARMAC IN 110V
DC INPSU ALARMGUIFAN
DC IN DC IN DC IN DC IN DC IN
OPTIC
ADXV-R-ORU
DL 1
DL OUT UL IN
DL 2DL 3DL 4DL 5DL 6
UL 1UL 2UL 3UL 4UL 5UL 6
E-ULE-DLSERVICELINKVHF-ULVHF-DL
DL IN UL OUT
SERVICE
CPL(-30dB)
ADXV-R-3XX
SERVER
DL IN UL OUT
SERVICE
CPL(-30dB)
ADXV-R-3XX
SERVER
DL IN UL OUT
SERVICE
CPL(-30dB)
ADXV-R-3XX
SERVER
DL IN UL OUT
SERVICE
CPL(-30dB)
ADXV-R-3XX
SERVER
DL IN UL OUT
SERVICE
CPL(-30dB)
ADXV-R-3XX
SERVER
SERVICE
ADXV-R-PSU
ALARM