User's Manual

Advanced RF Technologies, Inc.
19
• Local – The Local port can be used to communicate directly with the AXM700F-9543-ICS-X using a RJ-45
crossover cable or can also be used to connect the AXM700F-9543-ICS-X to an external modem box or the
optional internal Digi Transport WR-21.
2.2.2 Host/Remote Switch
The Host/Remote Switch allows the user to switch the default Repeater IP, Subnet Mask, and Gateway of the
LOCAL port of the repeater to an alternative setup. These settings can be adjusted by logging into the repeater in
HOST mode and configuring the settings under the Modem Box Setting section on the Install Page (section 5.4.4).
Once the settings are set, flipping the switch to the REMOTE position will reboot the repeater with the new
alternate settings. Please note that when the repeater is set to the REMOTE position, DHCP is disabled and the
repeater will not automatically assign an IP address to any device that connects directly to the repeater.
• Host IP: 192.168.63.1 (Fixed IP, unable to modify this IP address)
• Remote IP: 192.168.63.5 (Default IP, but can be modified in Host mode)
2.2.3 AC Power
Figure 2-3 AC Input Port
AC port is located at bottom of system.
Figure 2-4 AC On/Off Switch and AC Selection
The AC Power on/off switch and AC selection switch are located at left of PSU. The AXM700F-9543-ICS-X PSU
can operate at 110V AC and 220V AC. The user should verify that the AC input voltage selection switch is set to the
correct voltage before powering on the AXM700F-9543-ICS-X.
AC Selection switch
AC On/Off switch