User's Manual
Table Of Contents
- 1. Introduction
- 2. Overview
- 3. Alarms
- 4. Installation
- 5. PSR-78-9533 Web-GUI Setup
- 6. Maintenance Guide for PSR-78-9533 Repeater
- 7. Warranty and Repair Policy
- 8. Specifications
- 9. Mechanical Drawing
- 10. Appendix
Advanced RF Technologies, Inc.
22
2.3.5 Grounding
A ground cable is included in the box. The grounding terminal is located at the lower right-hand side of the BDA.
The grounding cable should be properly connected before powering on the equipment.
Figure 2-9 Ground Cable Terminal
Ground terminals located on the side of the repeater and can support a ground cable up to 1.25mm² (16AWG)
in diameter and should be permanently connected to a grounding bar.
2.3.6 Ethernet Port
The GUI port can be used to communicate directly with the PSR-78-9533 using an RJ-45 crossover cable. The
weatherproof cap must first be unscrewed to gain access to the GUI port.
Figure 2-10 Ethernet Port