User's Manual
Table Of Contents
- 1. Introduction
- 2. Overview
- 3. Alarms
- 4. Installation
- 5. PSR-78-9533 Web-GUI Setup
- 6. Maintenance Guide for PSR-78-9533 Repeater
- 7. Warranty and Repair Policy
- 8. Specifications
- 9. Mechanical Drawing
- 10. Appendix
Advanced RF Technologies, Inc.
31
5.2.1 Band Info
The Band Info section displays frequency information along with the corresponding bandwidths that have been
set from the Install tab. Input levels for each channel are also displayed in this section.
Figure 5-3 Band Info Display
5.2.2 Power & Gain
This section displays the Input, Gain, and Output for both downlink and uplink.
Figure 5-4 Power & Gain Display
Input [dBm] – Displays the in-band Downlink/Uplink signal level. The system will display “--.-“ when the input
level is < -90 dBm.
Outband [dBm] – Displays the out-band composite power.
Gain [dB]
- User Set: Displays the amount of gain that the user set.
- Actual: Displays the actual amount of gain that is currently in use.
Output [dB] – Displays the Downlink/Uplink composite output power levels. The system will display “--.-“, when
the output level is < +5 dBm.