User's Manual

Advanced RF Technologies, Inc.
15
2. OVERVIEW
2.1 LED
SDR-ICS-43 has an LED in the Lower left corner as shown in figure below.
Figure 2-1 LED
Table 2-1 RF Module LED Specifications
LED Indicator Specifications
Service
Green
System
is
Normal
Orange
Soft
Fail
Red Hard Fail
2.2 Host/Remote Switch
Figure 2-2 Host/Remote Switch
The Host/Remote Switch allows the user to switch the default Repeater IP, Subnet Mask, and Gateway of the
LOCAL port of the repeater to an alternative setup. These settings can be adjusted by logging into the repeater in
HOST mode and configuring the settings under the Modem Box Setting section on the Install Page(section 오류!
참조 원본을 찾을 수 없습니다.).
Once the settings are set, Push the switch to the REMOTE position will reboot the repeater with the new alternate
settings. Please note that when the repeater is set to the REMOTE position, DHCP is disabled and the repeater will
not automatically assign an IP address to any device that connects directly to the repeater.
· Host IP: 192.168.63.1 (Fixed IP, unable to modify this IP address)
· Remote IP: 192.168.63.5 (Default IP, but can be modified in Host mode)
2.3 Ethernet Port