User's Manual

Advanced RF Technologies, Inc.

4. INSTALLATION

4.1 Installation Procedures

4.1.1 Wall Mount Procedure

· Verify that the SDR-ICS-43 and mounting hole are in good condition

· Place the SDR-ICS-43 mounting template up against the wall and mark of mount holes

· Mount the SDR-ICS-43 to wall use the six (6) mounting hole on the wall mount bracket

· Connect the GND cable

· Connect the Antenna cable

· Connect the Power cable

Figure 4-1 SDR-ICS-43 Wall Mount

4.2 Grounding

· Install the ground cable that is included in the package at the side of the repeater as show in the figure below.

· The grounding terminal is located at lower right-hand side of the BDA. The grounding cable should be

properly connected before powering on the equipment.

Figure 4-2 Ground Cable Connection

· Ground terminals located on the side consisted of a 16mm²(6AWG) and should be permanently connected to

earth(Protective earthing conductor).

Mount bracket