Use and Care Manual

ASSEMBLY

Before commencing assembly familiarize your self with all the assembly components(see

chart and diagram); Ask a professional to install the fan

！

Use the following information as a guideline only. It is the user's responsibility to be sure the

location and the wall surface can handle the weight of this fan .

Wall fans are recommended for installation on 12 inch (300 mm) thick dry cement grout

solid walls or 4 x 5 inch wood studs/joists.

Use wall bracket as a template for locating the holes to be drilled.

After determining the hole locations, use an appropriate sized drill bit and, drill holes

through mounting surface.

It is recommended that a minimum of grade 5 fasteners be used.

The following are acceptable surfaces for mounting wall mount assembly.

STEEL SURFACE - When mounting to a steel surface, such as vertical I- beam, drill

through holes at pre- marked locations, using a 9/32" drill bit. Attach wall mount assembly to

mounting surface using 1/4"- 20 hex screw, in combination with 1/4" flat washers, 1/4" lock

washers, and 1/4"- 20 hex nuts.

MASONRY SURFACE - When mounting to a masonry surface use a 1/4" expansion type

bolt or 1/4" masonry lag with shield designed to handle the weight of this fan. Drill holes

at pre- marked locations using appropriate sized drill bit as recommended for the fastener.

Loosen the screws on the decoration ring until you can take out the front grill , and then

take off the front grill and fan blades;

Unscrew the four screws on the baffle, then install the rear grill and lock it with the four

screws;

Align the slot on the fan blade with the latch on the motor shaft, then install the M8 nut and

tighten the nut counterclockwise, then tighten the M6*8 screw.

Install the front grill, then tighten the screws, and then put the decorative cover on;

First fix the bracket on the four screws and tighten it with nuts;

Then install the machine head into the corresponding hole of the bracket and and lock the

knob;

Note: Make sure that the fan can be firmly fixed on the wall before powered on;