User Manual

Configura tion and Activation 6-47
Modify the parameter s as necessary, and then select OK once
complete.
 DAC Gain Choose the method for managing the
amplification of the analog signal that returns to the sensor:
− Auto Select this option to allow the monitor to
automatically optimize the amplification of the signal.
− Manual Select this option to e nter a fixed value
between -12db (lower amplification) and +12db (high
amplification) at which to amplify the signal.
 Surcharge Detection Select the Disable chec kbox to
prevent the monitor from implementing the Surcharge
Detection function when processing smart dep th data. For
locations that typically do not experience surcharges,
disabling Surcharge Detectio n eliminates the processing
time required for this function and, as a result, conserves
monitor power.
Sensor
 Physical Offset E nter the physical distance from the face of
the sensor to the crown (top) of the pipe. Refer to Chapter 3,
Sensor Installation and Connection, for instructions on
measuring the physical offset. The d e fault offset is 1.25 inches
(31.8 mm).
 Pipe Height This field displays the pipe height at the monitor
location, b a sed on the installation table. This parameter is not
editable fro m this location.
 Channel Select the channel number of the port on top of the
monitor to which this device is connected.