User Manual

Maintenance a n d Troubleshooting 10-15
Disconnec ting the PCB f rom the batt ery pac k
 Set the PCB temporarily asid e in a clean, dry location. Do
not discard! This PCB will be used with the replacement
battery pack.
10. Connec t the PCB to the replacement battery pack and then
secure the PCB to the side o f the pack with the re d band.
11. Run the loose cable from the battery pack through the hole in
the undersid e of the r etainer plug, and then seat the retainer
plug on top of the battery pack. Be sure to pull the excess
cable through the plug before fully seating the plug.
12. Lower the battery pack into the monitor canister, and then
connect the cable from the battery pack to the monitor
top/dome assembly.