User Manual

Index In-7
leveling
Surface Combo Sensor, 3-35
Ultrasonic Depth Sensor, 3-35
location information file (LIF), 2-3
low voltage, 10-8
M
magnet, 10-6
maintenance
checking t he sensors, 10-18
parts and supplies, 10-2
restrictions, 1-8
sensor inspection, 10-18
SIM card replacement, 10-21
system components, 10-2
manhole
conditions, 3-5
depth, 3-6
mounting the monitor
manhole rim, 7-7
manhole wall, 7-4
rung, 7-3
securing sensor cables, 3-64
maximum vel ocity, 6-24, 6-34, 6-39
memory, 2-1
Modbus, 2-24, 6-74
configuration, 9-10, D-2
connecting through the ExPAC
RS-232 port, 9-6
connecting through the ExPAC
RS-232 port in t he XBU S , 9-6
connecting through the ExPAC
RS-485 port, 9-2
connecting through the ExPAC
RS-485 port in t he XBU S , 9-2
output data registers, 9-11
SCADA, 9-1
setting up a wireless co nnection ,
9-9
Telog Ru-33, D-2
verifying output data, 6-74
XBUS, 9-2, 9-6
mode, 6-30, 6-45, 6-54
modem, 1-5
antenna connection to monitor,
4-14
antenna installation, 4-5
ceritification, 1-13
installing the SIM card, 4-11
installing the wireless antenna, 4-7
overview, 2-5
replacing the SIM card, 10-21
testing mo n itor cryou ts, 10-8
Modem Setup
APN username and password,
6-49
editing device, 6-49
moisture in pressure depth sensor,
10-19, 10-20
monitor
12-volt IS batt er y pack
checking vol tage, 10-8
replacement, 10-10
activation, 6-72
activity codes, 10-4, 10-5, C-1
configuration
Modbus, 9-10
confirmation, 10-4
connecting a water quality
sampler, 3-67
connecting communication cable
to ExP A C, 5-29
connecting communication cable
to XBUS, 5-29
connecting communication cable
to XIO, 5-29
connecting ground wire, 5-29,
5-34
connecting sensors, 3-67
connectors, 2-7
control drawing, 1-11
diagnostic codes, 10-4, 10-5
direct connectio n, 4-16
estimated battery life, 10-8
external DC power requ irements,
5-3
external power, 5-1