User Manual

3-28 ADS TRITON+ Manual
Sensor cabling
2. Continue securing the cables until reaching the Surface Combo
Sensor, Ultrasonic Depth Sensor, or top of the pipe.
3. Pull the ties until they are taut.
Warning: Do not over-tighten the cable ties or kink the
sensor cables! The sensor cable sheathes two components:
the electrical cables that operate the sensor and an air tube
that ventilates the pressure sensor (when applicable).
Over-tightening the ties or kinking the cable can damage or
restrict the air tube, causing erroneous pressure depth
readings. In addition, make sure the connector-end of the
sensor is not kinked, does not contain moisture, and
includes an attached dryer tube filled with active blue
desiccant.
4. Use the diagonal cutters to cut off the excess portion of the
cable ties.
Mounting the Surface Combo Sensor or
Ultrasonic Depth Sensor
The Surface Combo Sensor/Ultrasonic Depth Sensor is not mounted
prior to installation of the ring. The ring mechanism and sensor
mounting plate are assembled as detailed in Assembling the Ring
beginning on page 3-11. After the ring is installed at the monitoring
site, the sensor is inserted into the mounting plate and leveled (as
described in the following section).