Manual

6-10 IETG FlowHawk Manual
slave IDs used by the RTU or Telog unit when referencing
other devices. For Telog Ru-33 operations, IETG
recommends using 55 as the identifier through which to
request data from the monitor.
 Delay Response Enter the amount of time, in
milliseconds, following a request before the monitor
returns the requested data to the RTU (through the EMUX)
or the Telog Ru-33. The maximum delay allowed is 2000
ms. The default delay response is 10 ms.
13. Select OK to create a LIF for the location in the database and
exit the dialog.
The new monitor location with a single monitoring point now
exists in the database. A monitoring point is a location within
the pipe at which a sensor(s) is installed.
Adding a Second Monitoring Point
Establishing a new monitor location automatically creates one
monitoring point; however, each monitor location can support up to
two monitoring points. When applicable, add an additional
monitoring point to a location in the following way:
1. Select the location for which you want to create a second
monitoring point.
2. Click on the Monitoring Point button on the toolbar or select
Edit > New > Monitoring Point from the main menu.
Monitoring Point toolbar button
The second monitoring point displays with the selected
location under Monitoring Point 1.