Manual

In-8 IETG FlowHawk Manual
M
magnet, 8-5
maintenance
checking the sensors, 8-17
parts and supplies, 8-2
restrictions, 1-7
sensor inspection, 8-17
system components, 8-2
manhole
conditions, 3-5
corbel, 4-24
depth, 3-6
mounting the monitor
manhole wall, 7-3
rung, 7-2
securing sensor cables, 3-53
manhole depth, 6-8
manual collection, 6-8
maximum velocity, 6-29, 6-40, 6-45
memory, 2-1
MLI
editing device, 6-57
Modbus, 2-3, 2-6, 2-7, 6-67
configuration, 6-9, D-1, E-2
connecting the RTU to the
EMUX, 4-49
defining output data registers,
6-67
delay response, 6-10
diagnostics, D-1
EMUX system parameters, D-6
local port configuration, D-4
output data registers, D-7
system tests, D-7
Telog Ru-33, 2-8, 6-9, E-2
verifying output data, 6-67
Modbus ID, 6-10
mode, 6-35, 6-51, 6-55
modem
ceritification, 1-12
EMU, 4-26
EMUX
program, D-5
GSM module installation, 4-5
replacement in EMU, 8-25
selection, 6-58
Modem Setup
editing device, 6-53
moisture in pressure depth sensor,
8-18, 8-19
monitor
12-volt IS battery pack
checking voltage, 8-8
replacement, 8-10
activation, 6-63, 6-84
logs, 6-98
activation logs, 6-98
activity codes, 8-5, C-1
collecting data, 6-86
configuration, 6-3
adding a second monitoring
point, 6-10
creating a monitor location, 6-5
creating an installation table,
6-11
selecting devices, 6-17
confirmation, 8-4
connecting sensors, 3-56
connectors, 2-10
control drawing, 1-10
diagnostic codes, 8-5
direct connection, 4-52
estimated battery life, 8-8
external DC power requirements,
5-3
external power, 5-1
fuses
replacement, 8-32
GPRS communication, 2-5
inspection, 8-3
installation, 7-1
manhole wall, 7-3
rung, 7-2
memory, 2-1
new product warranty, 1-27
obtaining the IP address, 8-5
on-site communication, 4-52