Manual

Index In-11
power, 1-4
12-volt IS battery pack, 2-3, 2-11
battery pack, 1-4, 2-3
replacement, 8-10
checking battery pack voltage, 8-8
consumption, 5-3
diagnostic codes, 8-5
external, 2-12, 5-1
EMU, 2-3, 2-12
EMUX, 2-3, 2-12, 4-49
installation, 5-2
power supply, 5-4
power supply specifications,
A-15
requirements, 5-3
internal
12-volt IS battery pack, 2-11
battery voltage, 8-5
checking battery pack voltage,
8-8
replacing the battery pack, 8-10
regulator
replacement, 8-31
replacing fuses, 8-32
replacing the regulator, 8-31
power supply
installation and wiring, 5-4
specifications, A-15
pressure depth
editing sensor device parameters,
6-24, 6-47
measurement, 2-16, 2-19, 2-22
sensor diagnostics, 6-74
troubleshooting, 8-60
pressure depth sensor
replacing the desiccant in the dryer
tube, 8-19
replacing the dryer tube, 8-18
securing dryer tube to monitor,
3-58
processor board, 2-8
Profile software
activating the monitor, 6-63, 6-84
collecting data from a monitor,
6-86
creating a monitor location, 6-5
creating a second monitoring
point, 6-10
creating an installation table, 6-11
editing devices
Data Delivery, 6-55
Flow, 6-57
MLI, 6-57
Modem Setup, 6-53
Peak Combo Sensor, 6-22
Slimline Peak Combo Sensor,
6-22
Smart (Ultrasonic) Depth
Sensor, 6-49
Surface Combo Sensor, 6-34
Ultrasonic (Smart) Depth
Sensor, 6-49
launching, 6-4
low voltage, 8-8
Modbus, 6-9, E-2
registering, 6-4
running sensor (device)
diagnostics, 6-69
selecting devices, 6-17
setting communication parameters,
6-58
upgrading the monitor firmware,
6-95
Telog Ru-33, 6-9, E-2
viewing logs, 6-98
pump station, 3-5
PVC conduit, 4-24
Q
quadredundancy, 2-18