Manual

Location Information 7-17

CONFIDENTIAL – Covered by ADS Terms of Use and Confidentiality Agreement in Contract

 Overflow Configuration This section contains the parameters

defined by the System Administrator that indicate whether the location

should be considered an overflow location and threshold that must be

exceeded in order to initiate the overflow analysis.

− Overflow Select this checkbox to enable overflow analysis for

this monitoring point.

− Analysis Triggering Event This specifies the occurring event

for IntelliServe to begin analyzing if an overflow occurred and

whether the overflow was a dry or wet weather overflow event.

− Analysis Rain Gauges This table identifies which rain gauges

are included in the overflow analysis. A selected rain gauge is

collected to determine if a reported overflow is due to a dry or wet-

weather event.

 Show pipe table Select this link to view the pipe table for the current

location. Close the pipe table by choosing the Hide pipe table link.

 Show devices Select this link to view a list of devices associated

with the current location. Close the device list by choosing the Hide

devices link.

3. View parameters for a different rain gauge by repeating steps 1 and 2.

Viewing Flow Monitor Coordinates

View the geographic coordinate information for the flow monitor from the

Coordinates window. Perform the following to view the location coordinates

for a flow monitor:

1. Select Locations > Flow Monitors from the System Menu to display the

list of flow monitors in the system.

The Flow Monitors window displays.

2. Right-click on the location for which you want to view the coordinates, and

then choose the Coordinates option from the list.

The Flow Monitor Coordinates window displays the current information about

the location.