User Manual

IF1000series 27
©ads‐tecGmbH•Raiffeisenstr.14•70771Leinfelden‐Echterdingen

Deviceinfo
Anzeige
Selection Action


Deviceinfo Thisoptiondisplaysgeneraldevice
information.
Thescreenshowsthenameofthe
manufacturer,thedevicevariant,whether
aNVRAMcardisinstalled,thecurrent
firmwareversion,andthecurrentfirmware
build.

DeviceTest
Anzeige
Selction Action


Screen Startsthedisplaytest.
PressEntertostartthedisplaytest.
Performthistesttocheckthedisplayfor
correctfunctioning.Youcanvisuallycheck
whetherallcharactersaredisplayed
properlyonthedisplay.
Fourdifferenttestscreenswillappear,each
ofwhichwillneedtobeconfirmedby

pressinganyfrontpanelkey.
Whenthetestisfinished,youwill
automaticallybetakenbacktothemenu
view.


Keys Startsthekeytest.
PressEntertostartthekeytest.
Performthistesttocheckthekeysfor
correctfunctioning.
Youwillbepromptedtopressspecifickeys,
whereuponyoushouldpresstherespective
key.
Incaseonekeyisdefective,youmayexit
thetestusingthe
otherkeys.
Whenthetestisfinished,youwill
automaticallybetakenbacktothemenu
view.


Alarm Setsthealarmoutput.
Setsthealarmoutputandturnsonthe
alarmLED.
ThelettersALwillappearintheupperright
cornerofthedisplay,indicatingthatan
alarmwastriggered.ALwillcontinueto
flashuntilthealarmiseitherswitchedoff
oracknowledgedautomatically.
Perform
thistesttocheckthealarmoutput
forcorrectfunctioning.
