Owner manual

Quick Start Guide OPC7000 series mounting/commissioning

110523_ QUICK START GUIDE OPC7000_EN_DZ-HAND-91044-1 V1.0

en; German

Warning: Please observe installation guide

for OPC7022 enclosure!

PAGE 1
Quick Start Guide OPC7000 series mounting/commissioning Warning: Please observe installation guide for OPC7022 enclosure! 1 110523_ QUICK START GUIDE OPC7000_EN_DZ-HAND-91044-1 V1.0 © ads-tec GmbH • Raiffeisenstr.
PAGE 2
Quick Start Guide OPC7000 series mounting/commissioning 1. Installation 3. Commissioning 1.1 Fixing at the place of installation OPC7008 Before the device can be integrated in the panel, the tensioner fixing screws must be loosened until the tensioners open. (Pos. 1 – pos. 2). OPC7013/7015/7022 Cut the recess in the switch panel or switch cabinet door according to the dimensions shown in the installation picture. The tensioner fixing screws must be loosened.
PAGE 3
Quick Start Guide OPC7000 series mounting/commissioning 1. OPC7022 enclosure installation OPC7022 1.Remove the screws from all Quick snap tensioners. 3. Insert the OPC7022 into the enclosure. 2. Screw the provided M3x30 I/A threaded bolts one each into all of the Quick snap tensioners. Attention: For a correct device installation, the opened tensioners must be pushed into the panel! Refer to the picture. 4.