Quick Start Guide

!
CB34U Gateway Quick Start Guide
6) Device Specifications
5) Replacing the Battery
If the battery is damaged or unable to charge properly, a trouble condition will appear
via the Status LED turning Red. !
First, ensure that the battery is properly connected and AC Power has remained ON for
at least 48 hours. If the trouble condition still exists, the battery may need to be
replaced.!
To replace the battery, remove the rear cover to expose the battery, then replace with a
RT645 SLA battery. Note the correct orientation of the battery and polarity of the wires.!
FCC Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.!
#!
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:!
⁃
Reorient or relocate the receiving antenna.!
⁃
Increase the separation between the equipment and receiver.!
⁃
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.!
⁃
Consult the dealer or an experienced radio/TV technician for help.!
Unauthorized modification of the Radio is prohibited; user that changes or modifications not
expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.!
Troubleshooting Scenarios
Recommended Next Steps
Power LED = Blinking Yellow or Red
Confirm that the power cable is plugged in
Confirm that the breaker/switch for the outlet is on
4G LTE LED = Solid or Blinking Red
Try re-locating the CB34U to another suitable location with better LTE
reception
3G LED = Solid Red
Confirm that the alarm panel is powered on
Try re-locating the CB34U closer to the Alarm Panel
Status LED = Solid or Blinking Yellow
Ensure the back cover is tightly secured
Status LED = Solid or Blinking RED
Ensure the battery is properly connected
4) Troubleshooting
If any of the troubleshooting scenarios persist even after taking action on the recommended next steps,
contact your Alarm Service Provider for further information.
Operating Temperature
0 - 50° C
Storage Temperature
-20° - 60° C
Operating Humidity
93% RH Max. (Non-Cond.)
Power Adapter
120v AC; 12v DC, 0.5A
Battery
RT645 Sealed Lead Acid; 6V 4.5AH
Battery Life
6 - 8 years
Installation Range to Alarm Panel
50 feet (maximum)