Quick Installation Guide

ADT Video Doorbell

HARDWARE

INSTALLATION

DBC845 Wireless Doorbell Camera Installation

5. Secure the bracket with screws (No. 1 or No. 2). Please see Figure 4-5.

Note: Install the anchors if necessary.

Figure 4-5 Installing the Screws

6. Attach the doorbell camera to the mounting bracket. Make sure the

doorbell camera is firmly fixed and working properly.

Caution: To avoid damaging the rubber seal of the pogo pins,

please attach the camera to the mounting bracket flush. Mounting

bracket should lay flat against the wall. Over torqueing can warp the

bracket and cause it to lose contact with pins

Figure 4-6 Attaching the Camera to the Bracket

7. Turn on the breaker circuit.

8. Check that the chime is working normally by pushing the doorbell button.

If the AC wires are not connected properly, the LED will blink Red every

5 seconds.

Note: Please check if the chime sounds, if not, the chime type should be

changed in the ADT Pulse portal under Manage Devices.