Setup Guide

4
Side Panel
Reset/WPS
This button has two functions:
 WPS:
-WPS PBC Mode: When pressed and released (less then 3
seconds), the Camera will be in the WPS PBC mode (Auto
link mode).
-WPS Pin Code Mode: When pressed and held for over 3
seconds, the Camera will be in the WPS Pin Code mode.
 Reset: When pressed and held over 10 seconds, the LED will
be flashing red, which means the settings of Camera will be
set to their default values.
SD Card Slot
Insert the SD card for external storage. Use a screwdriver to remove
the screw and open the cover to insert the SD card if needed.
CAUTION:
 Risk of fire and burns under certain conditions
 Do not open, crush, short circuit and keep away from heat.
 Risk of explosion if the battery replaced by in incorrect type
 Follow instructions while using the battery
 Dispose of used batteries according to the instructions
 This product is intended to be supplied by a Listed Power Adapter or DC power source,
whose output meets LPS, rated 5Vdc, 2A minimum and Tma 50 degree C, if need further
assistance with purchasing the power source please contact Sercomm Corp. for further
information.

F
CC ID:P27SCE2R0