Installation Guide

ManualsBrandsADT ManualsElectronicsDoor/Window Sensor

SSH5R0-29 Door/Window Sensor

SSHX5R0-29 Premium Door/Window Sensor Installation Guide

Door/Window sensors are designed to secure the perimeter of the residential premise, and provide the ability to add various automation services.

The Door/Window sensor, which consists of a magnet that attaches to a door or window, will communicate door events to the home control

system or security panel. When the magnet is moved away from the sensor, a signal will be sent to the control panel that communicates the

changed state to the security system.

Frequency

1.9 GHz

Battery Type

CR2 Battery * 1

Operating Temperature

0 C to 55 C (32°F - 131°F) at 90% RH Non-condensing

Storage Temperature

-10 C to 60 C (14°F - 140°F)

Battery Life

SSH5R0-29 : 5 Years (50 trigger events per day @Room Temperature 25°C)

SSHX5R0-20: Over 3 Years (50 trigger events per day @Room Temperature 25°C)

Dimension

Sensor Device: 76 mm x 23.5 mm x 21 mm (3.0" x 0.92" x 0.83")

Magnet: 43 mm x 15 mm x 13 mm (1.69" x 0.59" x 0.51")

Initiate pairing on your home control system or security panel

using the instructions provided with it

1. Pull the exposed plastic tab from the sensor. (Figure 1)

2. The blue LED indicator will be lit for every seconds to indicate

the sensor is booting successfully

3. It will blink one time per seconds while attempting

to pair with the security controller.

4. If network is not found after 90 seconds, the sensor will go

into sleep mode. To wake the sensor again, you need to use

press tamper (Figure 2) 3 seconds to trigger a paring process, and

then sensor will repeat steps from 3 to 4.

1. Please make sure that the sensor and magnet is located less than 5 mm from each other. For optimal performance, it is highly

recommended to install the Door/Window sensor on the fixed frame and the magnet on the moving part of the door/window. Place the

sensor near the top of the door that close to the opening edge of the door. This is the mounting location for the sensor.

2. Use the provided double-sided tape on the sensor. Attach the sensor to the door. Press firmly and hold in place for a few seconds

3. Use provided double-sided tape on the magnet. Make sure the alignment of both sensor and magnet are facing each other (Figure 3). Press

firmly and hold in place for a few seconds.

1. The Blue Pairing LED will stay off during the normal operation.

2. The sensor is equipped with a tamper switch. If the cover of sensor is removed, the sensor will send an alarm to the home controller or

security system.

Introduction

Specification

Installation

Pairing Sensor

Operation

Figure 3

Figure 2

Figure 1

Summary of content (2 pages)

PAGE 1
SSH5R0-29 Door/Window Sensor SSHX5R0-29 Premium Door/Window Sensor Installation Guide Introduction Door/Window sensors are designed to secure the perimeter of the residential premise, and provide the ability to add various automation services. The Door/Window sensor, which consists of a magnet that attaches to a door or window, will communicate door events to the home control system or security panel.
PAGE 2
Reset to Factory Defaults & Reboot If sensor needs to be factory defaulted (for example, to prepare it for joining with a home controller or security system). 1. Remove sensor cover. 2. Remove the CR2 battery from sensor. 3. Depress the tamper switch before inserting the battery. 4. Insert the battery. The sensor should illuminate the LED once when boot-up/initialization tasks are complete. 5. Keep press 20 second then release the tamper switch while the blue LED is illuminated .