SDS

Page 3 of 5
8. EXPOSURE CONTROLS – PERSONAL PROTECTION
Engineering Control:
Local ventilation recommended when handling.
Control Parameters:
Time weighted average for 8-hour shift (TWA) – No data
Short Term Exposure Limit (STEL) – No data
Ceiling – No data
Biological Exposure Index (BEI) – No data
Respiratory Protection:
Though the smoke and odor generated by hot melting glue is not toxic, each
person has different sensitivity tolerances, it is recommended to wear a
mask.
Personal Protective
Equipment:
Hand protection – heat insulated gloves
Eye protection – safety goggles
Skin protection – wear long-sleeved or protective clothing.
Sanitary Measures:
No specific requirements.
9. PHYSICAL AND CHEMICAL PROPERTIES
Physical State:
Solid
Olfactory Threshold:
Not applicable
pH:
7.8
Flash Point:
Over 392°F / 200°C
Test Method:
Open cup
Auto-ignition
Temperature:
Not applicable
Specific Gravity:
.98 (H2O=1 @ 4°C)
Evaporation Rate:
Not applicable
Odor:
Resin
Softening Point:
185±10°F (85±5°C)
Boiling Point:
Not applicable
Flammability:
Not applicable
Decomposition
Temperature:
Not applicable
Explosion Limit:
Not applicable
Water Solubility:
Insoluble
Octanol / Water
Partition Coefficient
(Low Kow):
Not applicable
Color:
Clear
Viscosity:
8,800 -11,800 cps @ 350°F
10. STABILITY AND REACTIVITY
Stability:
Stable
Polymerization:
Hazardous polymerization will not occur.
Incompatibilities –
Materials to avoid:
Strong oxidizing agents.