User manual

ADT-TP3340DJ Three-axis Dispenser
- 4 -
Chapter I. System Introduction
This system is suitable for the three-dimensional dispenser motion control system with four or less axes. It
supports single point and continuous dispensing; integrates linear, arc and elliptical interpolation function
in any space; copies a simple graph in matrix mode; integrates delay, output, designated glue gun, waiting
input and other instructions, facilitating customers to realize own special processes; enters coordinates in
manual or instruction mode, converts the CAD graphs in the computer to PLT files and saves in the
controller, and then converts to the processing files of the controller; integrates double-station processing
mode, and allows alternative processing of two stations; each file can save up to 10,000 processing points.
Chapter II. Operation Instructions
I. Main Interface
工位信息显示区
功能菜单按钮
实时坐标显示区
加工操作按钮
加工状态显示条
When the controller is electrified, it enters the main interface shown above, which consists of the
following contents:
1. Workstation info display area:
Station I
File: w000
Points:
0000/0009
Start point: Set
Station info area
Processing state bar
Function menu buttons
Real-time coordinates area
Processing operation buttons
Station II
Not opened
Start Start
Processing mode
Auto
Allow opening gun
State: Stop Require resetting
Reset Pause Automatic dispensing Stop
Parameter settings
Hardware test
File management
Edit file