Programming instructions

ADT-CNC4620 Programming Manual
- 49 -
6) Before executing G73, the tool must specify the position of the initial point first, which
must be out of the program path limit range, or else the system alarms. If the position of the
initial point isn’t specified, the current point is the initial point.
7) The outside range of the program path is defined as below
This quadrant is the outside range of the program path
8) The offset direction of roughing depends on ns~nf program path (the processing path
program is A→B→C)
Condition
Result
X axis of C (nf block) > X axis of B (ns block); Z axis of C > Z axis of B ①
X axis of C (nf block) > X axis of B (ns block); Z axis of C < Z axis of B ②
X axis of C (nf block) < X axis of B (ns block); Z axis of C > Z axis of B ③
X axis of C (nf block) < X axis of B (ns block); Z axis of C < Z axis of B ④
X axis of C (nf block) = X axis of B (ns block) or
Z axis of C (nf block) = Z axis of B (ns block)
Generate
error
alarm