User manual

ADT-HC4500 CNC Flame/Plasma Controller
107
7) Connect to the power supply after the installation; in the start-up interface, press [F5] (Diagnose) →
[F2] (Define), use [Y↑] and [Y↓] to select upwards and downwards, and use [X→], [X←] to
select the state, then, press “Save” to change the corresponding port to the backup state.
Annex II Illustration of edition and processing
Press [F3] key in main interface to enter the edition option interface, where you can press [F1] key to
create a new processing file. Then, you can enter a file name and press [ENTER] key to enter the file edition
interface. In this chapter, we take cutting the following figure as an example. (Dashed line and arrow refer to
the direction of motion, solid line refers to the track of cutting, and “●” is the starting point of cutting.)
Remark: Because absolute coordinate is not used often, we do not introduce it in this chapter. In this
chapter, we use the relative coordinate.