User manual

ADT-HC4500 CNC Flame/Plasma Controller

Picture 2.3 Figure library interface

Operation: Press [X+], [X-], [Y+], or [Y-] to move the cursor up, down, left or right. Press [S↑], [S↓] to

page up or down, and press [ENTER] to enter the figure.

4. Copying processing files

Insert the USB disk with copied processing files into the USB port of control system. In main menu, press

[F3] (Edit) →[F3] (Udsk). If it is connected successfully, the interface will show the file names of files

stored in USB disk, as the following picture shows:

Picture 2.4 Copying processing files

At this time, press [Y+] or [Y-] to select the processing files to be copied, and press [F2] (SCpy) or

[ENTER] to copy. After that, a prompt will pop up when you can press any key to return to the main menu