User manual

ADT-HC4500 CNC Flame/Plasma Controller
16
circular arc shape.
The system acceleration and deceleration are set as follows: Press [F4] (Para) in main menu interface, and
press [F2] (Speed), then, set the speed in “StrSpeed” and “AddSpeed” (See picture below). Detailed definitions
are as follows:
2.8 Speed settings
1. [StrSpeed]--Start-up speed: Track-Move, a speed of starting up. For example, if the “StrSpeed” is set to be
300, the system speed is 0.3m at the just beginning. The value of start-up speed is determined by the
processing speed. The following list shows the reference value of start-up speed; actual data are subject to
the on-scene cutting effect.
CutSpeed (mm/minute) StrSpeed (mm/minute)
100-200 100
200-500 200
500-700 300
700-800 500
800-1000 600
1000-1300 700
1600-2000 1000
2000-3000 1500
3000-4000 2000
Table 2.8.1