User manual

ADT-HC4500 CNC Flame/Plasma Controller

2.12 Change of cutting gun nozzle

FBack and Cutting : Go back to the

interrupt with no cut then cut continue the program.

FBack and Stop : Go back to the

interrupt with no cut then stop program..

CBack and Cutting : Go back to the

interrupt with cutting then then cut continue program.

Process ringht here : cut continue program right here.

13. Displacement perforating

Picture 1 Picture 2

As picture 1, the outer is square steel plate and the inside rectangle is the workpiece to be cut. Assuming

that it is to cut the work piece from point A and the steel plate is of thick materials; then, it will cost a lot of

time to perforate. However, if it is to cut from the edge of steel plate (point B), the time of preheating

perforating may be saved. Detailed operations are as follows:

c In automatic processing → d Press [STOP] → e Press the corresponding X, and Y keys to move the

cutting gun to the edge of the steel plate →f Press [Start] again →g Select the relevant item in the popped up

dialogue box → h Press [ENTER], the coordinate will be moved to the current break point automatically and

proceed the processing of selected item.