User manual

ADT-HC4500 CNC Flame/Plasma Controller
22
Picture 2.15.1 Positioning mode of line selection
Direct change coordinate: the cutting gun does not move, but the coordinate is changed to the
coordinate of this line directly.
Auto move Gun: the cutting gun moves from the current position to the coordinate of selected
program line.
You can press [Y+] or [Y-] to change the mode of positioning when selecting line, and press
[ENTER] to select the line number (as Picture 2.15.2 shown below).
Input the line number by pressing the number key and then press [ENTER]. In case of doing fine
adjustment, you can press [X+] or [X-] to select the next line number.
16. Array
When you need to cut a single figure on big steel plate for several times, you can use the array function
to realize the simple array of this repeated figure.
In main menu interface, press [F1] (Auto) → [F4] (Grap) → [F4] (Pro):