User manual

ADT-HC4500 CNC Flame/Plasma Controller
24
Picture 2.16.3 After array graph
Matters need attention when you operate arraying
1) After the array, it will not save the original process file, like stop coordinate etc.
2) After Array, press 【Retn】enter into dealing interface, It can check if the size
suitable the plate or not. Afresh Array press 【F6】(restore)
17. Mirror
If you need to exchange the start point and the final point of the figure horizontally at 180˚ during
the cutting, you can do it by mirror function.
Press [F1] (Auto) → [F4] (Figure) → [F4] (Process) → [F1] (Rotate) → and press [F1] (Y mirror) / [F2]
(X mirror) / [F3] (XY mirror). As shown in the following picture: