User manual

ADT-HC4500 CNC Flame/Plasma Controller
31
Picture 3.1① Flame mode interface details:
1) Speed in %: can be adjusted by pressing [F↑] and [F↓]
2) Current moving speed
3) Name of processing file
4) Status of all electrovalves
5) Current The real-time coordinate value of X ,Y,Z
6) Current Gun gas of cutting diameter conpensation
7) Preheating time of preheat oxygen when perforating in flame cutting
8) Current working status of the system
9) Cutting machine model remind
10) System cuttent working status remind
11) System current remind of function mode status
12) Track display of current process graph
For plasma and flame mode interface, the difference is that the plasma mode does not have
preheating time and some electrovalves are different.
1.1 Details of program running
In interface as shown in Picture 3.1① and 3.1②, you can press [Start] to run the current program. Once
you have pressed the [Start] key, in any cutting mode, the cutting gun will start perforating on steel plate (M07
is default as perforating instruction), and then cutting. After the cutting, close the cutting oxygen. For M07
instruction, see section 4 of Chapter IV in this user manual.
If pause key is pressed during the cutting, the interface will be shown as Picture 3.1.1 and [F2] is changed
from [Manual] to [Forward]. If you press [F2] [Forward], the machine will travel forward along the track, and
when you press [◁] or [▷], [Forward] will be changed to [Manual], and the interface operations are of the
same.