User manual

ADT-HC4500 CNC Flame/Plasma Controller
34
Picture 3.1.2.2 Manual interface in flame mode
Picture 3.1.2.2 Manual interface in plasma mode
1.2.2.1 Inching
In manual interface as Picture 3.1.2.2, press [F1] (Point), and the above interface will show up
when the “Inching” is highlighted, with an input prompt “Input L value” at the bottom of the screen.
Press the number keys to input the length of inching, unit in mm. Then, you can press [X+], [X-], [Y+]
or [Y-] to allow the motor to run the input length relatively for each time. It’s the same for the plasma
function (Picture is omitted)