User manual

ADT-HC4500 CNC Flame/Plasma Controller
36
Picture 3.1.2.2.2 Breakpoint interface
It is the same as [F6] (spot) in auto interface, please refer to “Breakpoint” in 1.27 in this chapter.
1.2.2.3 Clear
In manual interface, you can press [F5] to clear the parameter in counting. If you press [X] or [Y] → [F5]
(Clear) → [ENTER], it is to clear the entire line of X and Y coordinates. To clear the last digit of value, you
can just press [DEL] on the panel.
1.2.2.4 Back to origin
In manual interface, when you press [F6], the coordinate value of X and Y is returned to 0 coordinate.
1.2.2.5 X, Y coordinate setting
In manual interface, pressing [X] and [Y] keys on panel enables to modify or clear the value of X and Y.
Once [X] or [Y] key is pressed, the interface on the left bottom will show the current coordinate, for
example “Input X value: X=+00123.456”, and at this time you can press [DEL] to clear the coordinate value
or press [F5] (Clear) to clear the entire line of value. After the setting, press [ENTER].
1.2.3 Backward
It is used in auto interface to return along original track due to the incomplete cutting when processing,
and the procedures are:
In auto processing → Press [Stop] to stop → Press [F3] (Backward) to enter backward function → if
the required position is arrived, press [Stop] → If it excesses the required position, press [F1] (Travel) to move
forward → Once the system is stable, you can then press [Start]. The system will run M07 perforating
instruction again directly and process in accordance with the program.
One backward action can only return to the previous perforating point.
1.2.4 Forward
During the processing, travel or backward motion in auto mode, if you press [Stop] to stop, the original
“Manual” displayed in menu will be changed to “Forward”. At this time, if you press [F2], the system will