User manual

ADT-HC4500 CNC Flame/Plasma Controller
38
Picture 3.1.2.5.1.1 Interface of figure processing
1.2.5.1.2. X, Y mirror
See “Mirror” in section 17 of chapter II.
1.2.5. 1.3 Rotation (Whir)
See “Calibration” in section 18 of Chapter II.
1.2.5. 1.4 Calibration
See “Calibration” in section 19 of Chapter II.
1.2.5. 1.5 Restoration
In rotation interface, you can press [F6] to restore the current figure to figure before mirroring, rotating or
calibrating.
1.2.5.1.6 Select line
See “Select line” in section 15 of Chapter II.
1.2.5.1.7 Select point (Sdot)
In processing interface as Picture 3.1.2.5.1, press [F3] (Sdot) to enter the interface of selecting point:
Picture 3.1.2.5.1.7 Select point
You can press [Y+] or [Y-] to change the positioning method for selecting perforating point.