User manual

ADT-HC4500 CNC Flame/Plasma Controller
42
Picture 2.2
User can get the difference process graph based on the parameter setting.
Parts Type: Hole-cutting and slicing. Related workpiece in the inner of graph when slicing; Related
workpiece in the outside of the graph when hole-cutting.
Lead in/out Line: Lead-in line (arc) is a reserved lead line (Arc) for avoided to over-burnning of point in
the cross the hole. Leads out line (arc) are specal function for plasma cutting, because lead-out line or lead-in
line will happening brake of arc under the plasma cutting. Lead in/out line (arc) hole-cutting is the inner of
graph, but the slicing is in the outside of graph.
Idle line: Idle distance from start point of process to start of cross-hole point.
Parameter setting of graphics library is limited, diameter of round hole can not bigger than diameter of
outside arc and the height from round hole center to botton side of hemline, the length if hemline can not less
than two times of top diameter. Because It can not show the correct composite figures if the the parameter
exceed the related scope. After set parameter, Press 【F5】 for preview, If Parameter exceed the related scope,
system will makte the reminding, then restore parameter as before set. If parameter setting coorect, Press【F6】
leading-in, enter intor auto interface, then Porcess file in the system had been changed to file of graphics
library.
When you set the parameter, Press 【DEL】it can delete the last no of currenct parameter, press key of
number for input value. Press 【CAN】parameter will clear, Press 【Y+】,【Y-】select parameter setting.
3. Edition
In main interface, press [F3] to enter the window of editing function menu as Picture 3.1, in which shows